Image Handler 4 (for v1.5.x) Support Thread

[mc12345678]

Well...my images are set to 150x150, 400x400, and 550x550. I don't seem to be having any issues in the back end of this, just the front. When I add product to cart, it takes me to the page not found.

I did go through my FTP and saw that it had files missing from the install, so I loaded them and am still having the same issue. Not sure what to do now.

So in regards to the image dimensions I am referring to, my original image is/was larger than 1024. I had no other image handler software installed and was using ZC1.5. At the time the issue appeared I had also listed the version of the prerequisite software either in that response or since then, but I am not in a position at the moment to identify that. My resized images were less than that, and decreasingly smaller like you listed.

So that said, and I know Diva has provided other feedback, but related to the referenced response, you stated that the files that did not successfully get loaded were again uploaded, but did not indicate what was done to accomplish that. Ie, were they uploaded to the default IH4 location and the auto_installer run again, were they uploaded to the default IH4 location only, were they merged with the location that IH4 would end up putting them, etc.

All that said also though and the additional discussion, there may seem to be something else going on or like in my case if the site is experiencing what mine was (upload of image with dimension in either height or width greater than approx. 1024 prevented display of any content on the page showing that image) then it could be that the image which was originally uploaded (and is attempted to be resized) is trying to be shown on that page and providing a page can not be found. (Assuming that the response of trying to "receive a message from her store" is a page not found issue.)

I don't believe the condition I describe above is specifically an IH4 issue so much as a limitation that is not handled/addressed through the interaction of IH4 with the prerequisite software. I haven't tried to troubleshoot that aspect, but work around it to verify all of my images are equal to or less than 1024 in both directions prior to upload. I think this is primarily a host problem on my side as no other changes to ZC or IH4 have been done that would cause this to occur.