Stripe.com payment integration module

[gernot]

Hi Alex,
I'm afraid writing a new module is way beyond my current capabilities, and the timeline I need to meet to use the functionality. Writing payment processor modules is definitely something I would like to do in future though, so fixing the Stripe module in stages seemed like a good start, and I am moving ahead reading the API docs little by little as I find the time.
I really don't care if all the functionality is not available (I doubt it was in the old module either), but I am worried by my lack of understanding in that I won't be able to tell if I have overlooked something critical.
Anyhow, if you have some insight/suggestions in that regard, please chime in, two pairs of eyes (and two brains) is better than one.

BTW what is the soon to be defunct API? Stripe versions its REST API, so I don't see what is going to be defunct there.

[alexexela]

We actually are using the module without problem (installed this at least 4 or 5 years ago), only made some minimum adjustment (mostly on the variables Stripe changed in the API over the years).

Quite a few of our clients are euro-based, so we are looking for a SCA solution. And the old Charge API is working but not what we need.

[gernot]

Got it. For European users indeed SCA support will be required. For me in Japan, not the case, so an easier bullet to bite.

[beco1979]

Just wondering if there has been any development on this. 2 weeks time SCA will be required and all cards will get declined if SCA not set up. Has anyone got a working solution? Or is it a case of setting up anther payment solution such as Paypal to avoid any problem?

[bitg]

Running ZC Version: v1.5.6c
And latest stripe module.

Every time I attempt to process a card outside of test mode I get the following notification:

Must provide source or customer.

Has anyone come up with a fix for this?

[gernot]

Hi bitg, have you made the changes in the previous page (listed by me)? I assume so, as I expect otherwise even test cards would not work perhaps. But since you say "latest strip module" it sounds like you did not make any changes yet?

[bitg]

Hi bitg, have you made the changes in the previous page (listed by me)? I assume so, as I expect otherwise even test cards would not work perhaps. But since you say "latest strip module" it sounds like you did not make any changes yet?

Thanks for the reply. I have not made any changes yet. I'll look back in the thread.

[dharrison]

Ok. Are they in the process of changing this?

[marton_1]

Ok. Are they in the process of changing this?

Who are "they"?
Nobody has claimed to be updating the plugin except you.

[dharrison]

Who are "they"?
Nobody has claimed to be updating the plugin except you.

I wouldn't even know where to start. I was just asking a question.