Here's one a little different from any others I've seen discussed in this topic:

I am working with a company that sells parts for trampolines. In order to get the proper measurements for replacement trampoline mats, they have the customer measure between the spring holes across the trampoline frame. The customer then enters the value in a cell. This is done four times. Then the total number of spring holes is entered in another cell. Finally, the length of the springs used on the trampoline is entered in another cell. They want these measurements (six cells total) to show up on the order form.

Is Atrributes the best way to accomplish this or is there a better way? I have attempted a few different things myself (in Attributes) but have thus far had no luck.

Any help or ideas would be appreciated.