Hi! I just upgraded to 1.3.7, and my admin says that the Linkpoint API is installed, but it's in testing mode:
Linkpoint/YourPay API (NOTE: Module is in testing mode)
How do I get this module out of testing mode? When I edit the settings, there's no setting for that - any help you can offer is greatly appreciated, thanks!
Results 1 to 3 of 3
-
26 Apr 2007, 03:16 AM #1
New Zenner
- Join Date
- Feb 2005
- Posts
- 17
- Plugin Contributions
- 0
Linkpoint API - Module is in testing mode? after upgrade
-
26 Apr 2007, 03:22 AM #2
Sensei
- Join Date
- Jan 2004
- Posts
- 66,373
- Blog Entries
- 7
- Plugin Contributions
- 274
Re: Linkpoint API - Module is in testing mode?
Go to your Linkpoint module in your Zen Cart admin area.
Write down the settings.
Click Remove.
Click Install.
Re-enter your desired settings.
You will now be able to set testing mode vs not.
You should do similarly for all other active payment and shipping modules..
Zen Cart - putting the dream of business ownership within reach of anyone!
Donate to: DrByte directly or to the Zen Cart team as a whole
Remember: Any code suggestions you see here are merely suggestions. You assume full responsibility for your use of any such suggestions, including any impact ANY alterations you make to your site may have on your PCI compliance.
Furthermore, any advice you see here about PCI matters is merely an opinion, and should not be relied upon as "official". Official PCI information should be obtained from the PCI Security Council directly or from one of their authorized Assessors.
-
26 Apr 2007, 03:36 AM #3
New Zenner
- Join Date
- Feb 2005
- Posts
- 17
- Plugin Contributions
- 0
Re: Linkpoint API - Module is in testing mode? after upgrade
Terrific! Thanks...
Similar Threads
-
can't change Testing:successful to testing declined in Linkpoint Pymnt Module
By WhiteWolf in forum Built-in Shipping and Payment ModulesReplies: 8Last Post: 3 Jul 2009, 04:27 PM -
Linkpoint- Module in Test Mode
By paulssports in forum Addon Payment ModulesReplies: 12Last Post: 23 Jan 2007, 07:49 PM -
Link Point API Not Working after upgrade (needed to remove+reinstall the module)
By KADesign in forum Upgrading from 1.3.x to 1.3.9Replies: 4Last Post: 5 Jan 2007, 05:26 PM
Bookmarks