Forums / Built-in Shipping and Payment Modules / cloned zone not being calculated when selected

cloned zone not being calculated when selected

Locked

Views: 960

Results 1 to 7 of 7

This thread is locked. New replies are disabled.

18 Oct 2008, 2:07 AM

#1

New Zenner

Join Date:: Sep 2008
Location:: Colorado
Posts:: 19
Plugin Contributions:: 0

cloned zone not being calculated when selected

I have cloned the zones module to allow for one day and two day shipping prices. It shows the correct prices at check out for each of the 3 options(standard,one day and two day).
But when I select any of them I always get the standard rate on the next page.
What did I miss?

20 Oct 2008, 3:49 AM

#2

New Zenner

Join Date:: Sep 2008
Location:: Colorado
Posts:: 19
Plugin Contributions:: 0

Re: cloned zone not being calculated when selected

clone error. solved

20 Oct 2008, 4:07 PM

#3

Oba-san

Join Date:: Sep 2003
Location:: Ohio
Posts:: 62,757
Plugin Contributions:: 1

Re: cloned zone not being calculated when selected

What was the secret of your success? :smile:

Cloning Zone Rates zones can be rather tricky ...

21 Oct 2008, 3:36 AM

#4

New Zenner

Join Date:: Sep 2008
Location:: Colorado
Posts:: 19
Plugin Contributions:: 0

Re: cloned zone not being calculated when selected

I think it must have been a cloning error unless underscores in the cloning name (zones_one) would make a difference which i doubt

21 Oct 2008, 4:09 AM

#5

Oba-san

Join Date:: Sep 2003
Location:: Ohio
Posts:: 62,757
Plugin Contributions:: 1

Re: cloned zone not being calculated when selected

zones_one will throw up ... as zones will conflict with it ... :eke:

21 Oct 2008, 4:08 PM

#6

New Zenner

Join Date:: Sep 2008
Location:: Colorado
Posts:: 19
Plugin Contributions:: 0

Re: cloned zone not being calculated when selected

so it was the underscores. Thanks.
I didn't really believe i had cloned wrong.
Find and replace is accurate in Komodo.

21 Oct 2008, 5:01 PM

#7

Oba-san

Join Date:: Sep 2003
Location:: Ohio
Posts:: 62,757
Plugin Contributions:: 1

Re: cloned zone not being calculated when selected

You just have to be careful when cloning the Zones Rate zones and Table Rates table as both words:
zones
table

are used in separate context from the actual lines to change ...

Take it slow, and you will not run into over cloning ... :cool: