Started by lamz on 22 Aug 2006, 11:39 AM · Views: 2,195
New Zenner
Hi
Is it possible to show more than 1 picture of a image? Like front and back etc?
Also
Is it possible to show related products`?
thanks in advance :)
Sensei
FAQ on adding multiple images to a product:
http://www.zen-cart.com/forum/faq.php?faq=cats_and_prods#faq_add_images
You could install the "cross sell" contribution (see the Downloads section) to handle "also recommended"
.
Zen Cart - putting the dream of business ownership within reach of anyone!
Donate to: DrByte directly or to the Zen Cart team as a whole
Remember: Any code suggestions you see here are merely suggestions. You assume full responsibility for your use of any such suggestions, including any impact ANY alterations you make to your site may have on your PCI compliance.
Furthermore, any advice you see here about PCI matters is merely an opinion, and should not be relied upon as "official". Official PCI information should be obtained from the PCI Security Council directly or from one of their authorized Assessors.
New Zenner
ok tnx :)
a last question:
is it possible to use 2 different image sizes in the shop:
i have some products thats tall and some thats wide and would
like ti use a diffrent imagesize for them
tnx in advance :)
Sensei
you could use proportional images to accomplish something close to that.
If you set one of your image dimensions to blank (or 0) for a particular image, the other dimension is auto-calculated for you, effectively making the supplied number a "maximum" width (or height if you specified height).
.
Zen Cart - putting the dream of business ownership within reach of anyone!
Donate to: DrByte directly or to the Zen Cart team as a whole
Remember: Any code suggestions you see here are merely suggestions. You assume full responsibility for your use of any such suggestions, including any impact ANY alterations you make to your site may have on your PCI compliance.
Furthermore, any advice you see here about PCI matters is merely an opinion, and should not be relied upon as "official". Official PCI information should be obtained from the PCI Security Council directly or from one of their authorized Assessors.
New Zenner
Hi!
I've read the post referenced above, and meticulously followed it, as far as I can tell. But... only my one product image shows up on the page, not the additonal two images which I put in the "medium" and "large" folders within the "images" folder. They start with the same filename as the basic image. (listed under "products image" on my product info page in Admin).
I've checked everything over several times and can't see what the problem is.
Is there anything else I need to do to get the additional images to show up, or should it just happen "auto-magically"? I thought it was the latter... I'm baffled...
Thanks!
Adam
New Zenner
I'm thinking I should post this as a new subject - that's what I'll do. Couldn't edit my above post to delete it or I would have done that as well!
Thanks,
adam
Tell staff why this post should be reviewed.